1/4" x 10 ft. New Primeline Hydraulic Shear Model 10H250

Stock#: 4375

Category Shears, Power Squaring (In)

Request A Quote

New Primeline Hydraulic Shear
Model 10H250

FEATURES: 
 Swing-beam design with streamline appearance
 All steel frame, featuring box-type welded construction of the
 main frame and blade beam, with dimensions optimized
 by computer-assisted design to guarantee maximum rigidity
 Accurate upper blade beam guiding system
 Swivel-mounted hydraulic cylinders for maximum durability. 
 Hydraulic unit located for convenient and easy access
 High-pressure hydraulic holddowns
 Low rake-angle of upper blade (minimizing distortion of narrow
 cut-offs)
 Rapid, single-point blade-clearance (blade-gap) adjustment device
 Easy blade re-setting
 Slow-stroking device (inching) to check blade clearance
 Easy adjustment of cutting length for shortening stroke when
 desirable for cutting narrow materials. When the stroke is
 shortened, the number of strokes per minute increases
 proportionately.
 Elgo go-to control with 200 steps of memory
 Deep gap (throat) to allow shearing of plates longer than the length
 of the blades, using slitting technique
 Double-acting cylinders for return of blade beam
 Ball transfers in machine table
 Little maintenance required as there are very few moving parts,
 the main ones being self-lubricated
 Rear bottom side of shear completely open for addition of stacking
 and conveying devices
 Light beam shearing gauge
 Jack bolts in machine frame for blade adjustment after sharpening,
 eliminating the need for shims
 Low voltage at the controls

Standard equipment:
 The complete hydraulic system with motor and controls
 Elgo "touch" control for go-to and sequential programming
 Rapid, single-point blade-clearance (blade-gap) adjustment device
 Special shock-resistant blades (59-60 HRC) suitable for cutting
 quantities of mild steel and stainless steel to the indicated capacities
 Hydraulic fluid
 Finger guard
 Left-hand squaring arm, 40", with scale in inches, fitted with two
 squaring guides and one retractable stop
 2 Support arms with scale and flip stops
 Light-beam shearing gauge
 Hydraulic pump with three-year replacement warranty
 Electrics for 3/60/220 or 3/60/440. Low voltage at the controls.
 Key-lock switch for On/Off for the power supply. Emergency
 stop palm button.
 Electric foot switch on a trailing lead
 Operating manual, maintenance tools
 
SAFETY: 
The cost of bodily injury and poor moral, significantly increase operating expenses. 
Comprehensive training programs, which include safety instructions, are your best protection 
against employee injury. For operator safety programs to be successful, they must be applied with 
the addition of safety systems. PRIMELINE Shears are designed with the operator's safety in 
mind. PRIMELINE shears offer ADDITIONAL FEATURES, which that can be purchased to enhance 
the safety of your operators. See the various Safety options listed in this quotation.

10H250 SPECIFICATIONS: 
Capacity - mild steel up to 80000 PSI with yield
strengths at or below 50% of tensile strength for maximum
capacity shown - 10' x 1/4"
Capacity - mild stainless steel - 10' x 5/32"
 Cutting Length - 122"
 Throat depth (gap) - 9.84"
 Rake angle of upper blade - 1 1/2 degrees
 Strokes per minute - full length at full capacity - 21
 Strokes per minute - full length at 50% capacity - 26
 Backgauge range - 39", swing-up type
 Hydraulic holddowns - 14
 Motor HP - 16
 Overall Dimensions - (L x W x H) 144" x 104" x 63"
 Approximate weight - 13,200#

FOB: Maryland