© 2022 All rights reserved
Category Rolls, Plate Bending (incld Pinch)Request A Quote
Diameter of all rolls – 4.72"
Motors - 2 HP drive motor; 1 HP hydraulic system motor
Approximate rolling speed - 21.00' per minute
Net weight - approximately 4070#
All steel frame
Most rigid frame, drop end and clamping roll parallelism unit
Machine frame stress relieved
Upper and lower pinch rolls driven
All rolls mounted in ball or roller bearings
Powered hydraulic adjustment of the lower pinching roll
Powered hydraulic adjustment of the rear bending roll, with push button control and electronic digital readout for roll position
Design for lineal guided rear roll to minimize flat ends
Hydraulic drop end Top roll permanently balanced when the drop end is opened
Hydraulic unit with motor and controls for lower roll and rear bending roll adjustment and for the hydraulic drop end SAE 1050 high strength steel rolls heat treated (hardened) to 55 - 60 Rc
Portable control console mounted on wheels for operator convenience (allows operator to position for his/her convenience)
Components from American and European sources
Electrics for 3/60/220 or 440, with overload and under voltage protection.
Low voltage at the controls.
Safety cable at front and rear of machine
Cone bending attachment Powered tilting of rear bending roll for cone rolling Electronic digital readout to indicate position of the rear bending roll
Grooves in lower rolls for 1/4", 3/8", 1/2" round bar (must be ordered from the factory to be included at no charge)